Lighting issue - Easy 10 Rendering

[xavin]

Hello Guys. I am new to this software and would like to check why some of the spot light source are light up but some are not. I am using easy 10 for rendering.

[Fletch]

Difficult to tell. It could be that some of the lights have been placed too high inside of the cans and are actually inside of the ceiling? It could be that the lights are just turned off? See the "all on" function in the light editor.

Try with Easy Low - very fast test rendering, then jump to 9 or 10 when ready. Easy 10 is for rendering lasers through crystals, not for Arch. interiors - use Easy 09 it is 2x faster than Easy 10.